Last Updated: November 4, 2026
You can build a granny flat yourself in Australia as an owner-builder, but the electrical, plumbing and drainage must be done by licensed trades, and the flat needs a building permit like any new dwelling. The most DIY-friendly route is a factory-built modular unit: POMO’s TRUECORE steel modular buildings are published from $27,750 inc GST for a 20 m² unit at lockup stage, so the structure arrives finished to lockup and your work is the site, the connections (through licensed trades) and the fit-out.
What can you do yourself on a granny flat?
| Job | Can an owner-builder do it? | Notes |
|---|---|---|
| Managing the project, booking trades and inspections | Yes | This is the owner-builder’s main role, and it carries the builder’s legal duties |
| Site clearing, set-out, paths and landscaping | Yes, within your skills | Machine work near services needs a dial-before-you-dig check |
| Footings, stumps, screw piles or slab | Usually engaged out | Must match the engineer’s design and pass the footing inspection |
| Placing a modular unit | No: supplier and crane company | Needs truck and crane access to the spot on your block |
| Electrical work | No | Licensed electrician in every state |
| Plumbing, drainage and gas | No | Licensed plumber or gasfitter in every state |
| Internal fit-out: painting, flooring, cabinetry | Yes, within your skills | Wet-area waterproofing must meet the NCC and is inspected in some states |
Do you need an owner-builder permit for a granny flat?
Usually yes. Each state sets a value above which you need owner-builder approval before you can get the building permit:
| State | Owner-builder approval needed when the work is over | Regulator |
|---|---|---|
| Victoria | $20,000 (certificate of consent) | Building and Plumbing Commission |
| New South Wales | $10,000 (owner-builder permit) | NSW Fair Trading |
| Queensland | $11,000 inc GST (owner-builder permit) | QBCC |
| Western Australia | $20,000 (owner-builder approval) | Building and Energy |
For the other states and the course and repeat-build rules, see the state-by-state table at Owner Builder Help.
How big can a DIY granny flat be?
- Victoria: a small second dwelling of up to 80 m² (from 15 October 2026, amendment VC306) usually needs no planning permit if it meets the standards, but always needs a building permit (Planning Victoria). Read our granny flat rules for Victoria.
- New South Wales: a secondary dwelling can be up to 60 m² under the Housing SEPP, with complying development on lots of at least 450 m² (NSW Planning).
- Queensland: the council planning scheme sets the size, and since 2022 a secondary dwelling can be rented to anyone.
The building code depends on the state: Victoria and Tasmania build to NCC 2025 from 1 May 2026; WA and the ACT adopted NCC 2025 on 1 May 2026 but accept NCC 2022 until 1 May 2027; NSW and Queensland stay on NCC 2022 until 1 May 2027; South Australia uses NCC 2022 Amendment 2 until 30 April 2027; the Northern Territory has not adopted NCC 2025 (ABCB).
How much does a DIY modular granny flat cost?
These are POMO’s published prices, all at lockup stage and inc GST. They include structural engineering certificates, a NatHERS energy assessment and delivery within Victoria. Fit-out is additional.
| Size | Typical use | Published price (lockup, inc GST) |
|---|---|---|
| 20 m² | Studio, home office, single occupant | $27,750 |
| 40 m² | One-bedroom granny flat | $36,120 |
| 60 m² | Two-bedroom granny flat | From $62,150 |
Everything after lockup is priced for your site. We don’t publish a “typical total” or a multiplier, because the totals swing with your block and your finish. Get a written quote for each line:
| Cost line | Who quotes it | What changes the price |
|---|---|---|
| Soil test, survey and drawings for the permit | Geotechnical engineer, surveyor, drafter | Site size and complexity |
| Building permit and any planning permit or DA | Building surveyor or certifier, council | Approval pathway and overlays |
| Footings or slab | Concreter or footing contractor | Soil class, slope, stumps versus slab |
| Transport outside Victoria and crane | Supplier and crane company | Distance, access, crane size |
| Water, sewer, power and stormwater connections | Licensed plumber and electrician | Distance to existing services |
| Fit-out from lockup | You and your trades | Kitchen, bathroom and flooring choices |
Would rather erect a flat-pack steel frame yourself? Compare structure-only kit designs on Kit Home Floor Plans.
Steps to build a DIY granny flat
- Check the rules for your lot: size limit, setbacks, overlays, bushfire (BAL) rating and flood level.
- Choose the size and layout and get a supplier quote with delivery to your site.
- Get owner-builder approval if the value is over your state’s threshold.
- Apply for the building permit (and planning permit or DA if needed) with the drawings, engineering and energy rating.
- Prepare the site and build the footings; book the footing inspection.
- Delivery and placement of the unit by truck and crane.
- Connect services through licensed trades, then fit out.
- Final inspection and occupancy permit or certificate before anyone lives in it.
Common DIY granny flat mistakes
- Pricing the building but not the connections, transport and crane.
- Starting work before owner-builder approval and the building permit are issued.
- Covering footings or wet areas before the inspection.
- Choosing a spot the delivery truck and crane cannot reach.
Can I build a granny flat myself in Australia?
Yes, as an owner-builder in every state, once you have any required owner-builder approval and the building permit. Electrical, plumbing, drainage and gas work must still be done by licensed trades.
How much does a DIY granny flat cost?
POMO’s modular buildings are published at lockup stage from $27,750 inc GST for 20 square metres, $36,120 inc GST for 40 square metres and from $62,150 inc GST for 60 square metres, including delivery within Victoria. Footings, connections, fit-out and permits are quoted for your site.
Do I need a building permit for a modular granny flat?
Yes. A granny flat is a dwelling, so it needs a building permit or certificate whether it is built on site or in a factory. Some sites also need a planning permit or DA.
How big can a granny flat be in Victoria?
From 15 October 2026 a small second dwelling in Victoria can be up to 80 square metres under amendment VC306. It usually needs no planning permit if it meets the standards, but it always needs a building permit.
Get a price for your site
Tell us your block and the size you need, and we will quote the unit with delivery. Phone 1300 866 131 or use the enquiry form below.